exercises:2016_uzh_cmest:faq
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
exercises:2016_uzh_cmest:faq [2016/12/05 11:05] – [How do I obtain a charge density difference?] scaravati | exercises:2016_uzh_cmest:faq [2016/12/06 11:31] – [How do I restart a calculation?] scaravati | ||
---|---|---|---|
Line 42: | Line 42: | ||
</ | </ | ||
- | ===== How do I build a slab to model a surface? ===== | + | ===== How do I build a slab model for a surface? ===== |
E.g. by using [[http:// | E.g. by using [[http:// | ||
- | A tutorial | + | A tutorial is available [[http:// |
Vesta comes preinstalled on '' | Vesta comes preinstalled on '' | ||
Line 51: | Line 51: | ||
module load vesta | module load vesta | ||
</ | </ | ||
+ | |||
+ | ===== How do I obtain the stress tensor? ===== | ||
+ | |||
+ | You have to add the following snippet to the input file: | ||
+ | < | ||
+ | & | ||
+ | ... | ||
+ | STRESS_TENSOR ANALYTICAL | ||
+ | |||
+ | & | ||
+ | &END STRESS_TENSOR | ||
+ | &END PRINT | ||
+ | ... | ||
+ | &END FORCE_EVAL | ||
+ | </ | ||
+ | |||
+ | <note tip>Your calculation should be set up in such a way that forces are being calculated: | ||
+ | e.g. '' | ||
+ | |||
+ | |||
+ | ===== How do I restart a calculation? | ||
+ | |||
+ | There are two restart files usually produced by a run: | ||
+ | * a binary file, typically ''//< | ||
+ | * a ASCII file, typically ''//< | ||
+ | |||
+ | To employ the WFs restart file it's enough to change in the input file '' | ||
+ | into '' | ||
+ | |||
+ | Instead, to restart e.g. the positions of the atoms along a GEO_OPT run, you should add | ||
+ | a [[https:// | ||
+ | < | ||
+ | & | ||
+ | RESTART_FILE_NAME < | ||
+ | &END EXT_RESTART | ||
+ | </ | ||
+ | |||
+ | where you should replace ''//< | ||
exercises/2016_uzh_cmest/faq.txt · Last modified: 2020/08/21 10:15 by 127.0.0.1